• Fluorescent Magnetic Ink. FLUXO 6 for Magnetic Particle Inspection

Fluorescent Magnetic Ink for Magnetic Particle Inspection  

500 ml Aerosol cans

Conform to EN ISO 9934-2 and AMS.

Performance: 70mm in reference block type 2

Aspect & colour: red suspension

Flash Point : > 80°C

Particles size: D50% between 3 and 7 μm D10%>1,5 μm - D90%<40 μm

Fluorescence coefficient: ß ≈ 2,5 cd.W-1

Corrosion test: level 0 (according standard ISO 9934-2)

Density : 815 g.cm-3 (15°C)

Settlement rate (1 hour) : min 0,1 ml/100 ml

 The part is subjected to an intense magnetic flux by Magnetic Particle Inspection, which is deviated by the presence of a defect. This escape attracts the particles of the product and the defects now are clearly visible as fluorescent lines.

Components are magnetized and Fluorescent Magnetic Ink FLUXO 6 is applied to the test area, normally by spraying immediately prior to and during magnetization. Application of Fluorescent Magnetic Ink FLUXO 6 should cease before the magnetization is switched off. Defects will show up as well defined fluorescent indications and inspection should take place in good UV Light of at least 1500 μW/cm².


Fluorescent Magnetic Ink. FLUXO 6 for Magnetic Particle Inspection

  • Product Code: FLUXO 6
  • Availability: In Stock
4.99€